|
…
|
||
|---|---|---|
| .. | ||
| config.h | ||
| f411.c | ||
| f411.h | ||
| halconf.h | ||
| mcuconf.h | ||
| post_config.h | ||
| readme.md | ||
| rules.mk | ||
readme.md
Drashna's Blackpill Tractyl Manuform (5x6) with a right side trackball
- System Timer on TIM5
- VBUS mod, using PB10 -- does work, but not on my tractyl... bad soldering probably
- Split Hand Pin, using PC14
- Full Duplex Serial/USART using PA2 and PA3 on USART2
- PWM Audio using PB1 and TIM3 and GPT on TIM4
- PWM WS2812 RGB using PA1 TIM2
- 8KB SPI EEPROM chip sharing PA5-PA7 on SPI1 with PA4 as CS pin
- pmw3360 sensor sharing PA5-PA7 on SPI1, with B0 as CS pin
- Encoder using PA13 and PA14
- SSD1306 OLED display (128x64) using PB8-PB9 on I2C1
- Pull-up resistor (22k) on PA10 to fix reset issue.
- Pull-up resistor (5.1k) on PA1 for WS2812 LED support, and wire it's VCC to the 5V pin.
- Pins PA9 is meant for VBUS sense, and has an internal pulldown resistor. A 5.1k pullup resistor can work (but should be avoided)
- Pins PA11 and A12 are not useable because they're used for USB connection, and can't be shared.
- Pin PB2 is used by BOOT1, and is unusable
Keyboard Info
- Keyboard Maintainer: Drashna Jael're
- Hardware Supported: Design files, WeAct BlackPill (F411), PMW3360 Optical Sensor
Make example for this keyboard (after setting up your build environment):
make handwired/tractyl_manuform/5x6_right/f411:default
Flashing example for this keyboard:
make handwired/tractyl_manuform/5x6_right/f411:default:flash
See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.
Bootloader
- Bootmagic reset: Hold down the top right key on the right side, or the top left key on the left side while plugging in.
- Physical reset button: Briefly press the "USER" button on the BlackPill
- Keycode in layout: Press the key mapped to
RESET.