6209122213
* [Keymap] Add vitoni layout for GMMK Pro (ISO) Keymap has layered cursor keys similar to laptop keyboards. * Configure RGB defaults for startup * Configure encoder to change value/brightness on FN layer * Remove FN layer and add dedicated RGB layer * Make RGB layer sticky (using TG) to avoid holding FN while configuring RGB * Add RGB indicators for active layers * Add RGB indicator for active RESET mode Signed-off-by: Victor Toni <victor.toni@gmail.com> * Configure idle / USB suspend settings * Add RGB fade in when resuming after suspend * Add RGB fade out before suspend * Add fade out before idle * Add breathe effect when idle |
||
|---|---|---|
| .. | ||
| keymaps | ||
| config.h | ||
| info.json | ||
| iso.c | ||
| iso.h | ||
| readme.md | ||
| rules.mk | ||
GMMK PRO (ISO)
A tenkeyless 75% keyboard made and sold by Glorious LLC. Equipped with the STM32 ARM Cortex-M4 microcontroller, with support for rotary encoders and three additional layouts. More info at Glorious
- Keyboard Maintainer: GloriousThrall
- Hardware Supported: GMMK Pro
- Hardware Availability: GloriousPCGaming.com
Make example for this keyboard (after setting up your build environment):
make gmmk/pro/iso:default
Flashing example for this keyboard:
make gmmk/pro/iso:default:flash
To reset the board into bootloader mode, do one of the following:
- Hold the Reset switch mounted on the bottom side of the PCB while connecting the USB cable
- Hold the Escape key while connecting the USB cable (also erases persistent settings)
- Fn+Backspace will reset the board to bootloader mode if you have flashed the default QMK keymap
See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.
Case Screw Replacements
Many users report stripped case screws when disassembling the board.
The stock case screws are:
- Thread: M2
- Thread length: ~5 mm
- Head diameter: ~3.8 mm
- Head counterbore diameter: ~4.0 mm
- Head counterbore depth: ~1.9 mm
Most M2x5mm screws should fit fine, although it's best to ensure that the screw head will fit inside the counterbore. For reference, this hex socket head screw from McMaster-Carr should fit nearly flush (head will protrude above the counterbore by ~0.1 mm).